Pneumatic 3-Way Valve Enters Production
Leave a message
Units were run on dosing skids before the line was released, so the 2 second stroke is measured on a loaded circuit, not on a bench. Body options are UPVC, CPVC and PVDF, holding continuous service at or below 55 °C, 80 °C and a -20 to 100 °C band respectively. Single weight is 1029 g, overall size 166 x 97 x 177 mm.
A hand-operated two-way valve needs 30 to 60 seconds per re-route, and that pause repeats every shift change. One three-way unit replaces a pair of two-way valves plus the connecting elbows, which removes two joints that would otherwise need periodic re-torquing and cuts the potential leak points on that circuit by roughly half. Threaded ends let a fitter pull the ball core for seal inspection without cutting into fixed pipework.
Buyers choose L-port for simple diversion, T-port when two incoming streams need continuous mixing, and EPDM or FKM seals according to the medium. Both double-acting and spring-return actuators are available. Cartons are sized to leave about 1 cm of padding on every side of the valve; measured weight and carton size can shift slightly between batches, so bulk orders are confirmed against the packing plan from your account manager.
Specification sheet and drawings: luxu@ydkl-plastic.com / 120720338@qq.com
Related pages
3-Channel Motorized Dosing Valve System - published 28 October 2026
PPH 3-Way Union Ball Valve - published 21 September 2026






